![]() ![]() then finally SIProxd until I get an unknown SIP provider working. SIProxd however gives a little priority apparently. But everywhere else just need the incoming WAN rules. Then they changed a few things and it became unnecessary. You have to play and experiment sometimes. Not originally designed to be behind NAT. ![]() VOIP was not originally designed for residential service. Companies now do things just different enough to avoid the same fate.Īlso. Keep in mind that companies are still trying to avoid what happened to Vonage back in the day. Some *** VoIP insists on using a fixed source port, Generally speaking you should not need to do anything special for internal phones connecting an external PBX. Try pinging the domain/IP of the server and check your account configuration.Said in VoIP phones that will not register behind a PFsense firewall: the contact on the other side uses an unsupported by his PBX server audio codec (which causes him to seem to be offline).the contact you are trying to dial is offline.the outbound proxy provided is not needed or incorrect.the transport type is not selected as necessary.the server information is not provided correctly.SIP 923 / No DNS results / Service or option unavailable You might need to ask your provider or administrator for more assistance. Dowble check if the audio codecs that you are using are supported. when the destination does not wish to participate in the call, or cannot do so.If so, please check with your server administrator or Vo IP provider if SIP REFER is suported. Make sure your firewall is not blocking the default ports used by Zoiper. This error message indicatesa network issue. SIP 504 / Gateway timeout / Recovery on timer expiry Please make sure all account details and the server hostname are entered correctly. This error message is shown when the server is unable to process the request for some reason, for example when the service you are trying to use is unavailable. Report the issue to your provider for more assistance. ![]() Zoiper did not generate this error, it is just showing what the server sent to it. The server could not fulfill the request due to an unexpected condition. The account you are trying to dial appears to be unavailable. SIP 480 / Temporarily unavailable / No user response It seems that you are trying to use an unsupported codec.Ĭontact your VoIP provider to find which audio codecs are enabled for your account. SIP 415 / Unsupported media type / Service or option not implemented Please retry your request later or report the issue to your network administrator. If the issue remains unaffected or if it did not exist before (appeared recently), you should contact your ITSP or network administrator to check if any changes had been introduced to your network setup. ![]() Make sure that a routing device/firewall is not blocking any ports used by Zoiper.Īlso, make sure you have configured the correct transport setting in Zoiper according to your provider's instructions. You should try altering STUN and rport settings in your account configuration. Try different combinations (STUN disabled, RPort enabled, vice-versa, both disabled and both enabled ) and try to register again. You can find both options in your account configuration under the "Advanced" sub-tab. Altering STUN and RPort for the affected account could help.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |